Please perform the following steps listed below prior to reviewing the above video. It is best to watch the video in Full Screen mode.
**Note: The video and steps presented here are for Creo Parametric 1.0 and Windchill 10.0. There are slight variations and differences when using Windchill 9.0 and 9.1 and Creo/Elements Pro (Wildfire 4.0 & 5.0).
In order to begin, you must have at least one saved version of the model in Windchill (9.0 M030+).
Create two workspaces that have the same version (in my example it is A.1) of the model added to them.
Start Creo Parametric or Creo/Elements Pro 4.0+ linked to one of the workspaces and save a newly modified or different iteration. Repeat for the second workspace.
Check-in one of those iterations into Windchill (in my example it is A.2). This will make the iteration in the other workspace out-of-date.
Have Creo Parametric / Creo/Elements Pro tied to the workspace w/ the out-of-date model and follow the above video.
In this video tutorial you will learn to setup Creo Parametric so that when creating an extrude feature, the direction of the feature determines if the extrude will add or remove material from the model. ... (Show more)(Show less)
PTC University Expert Model Analysis (XMA) deepens your understanding of PTC Creo Parametric and PTC Pro/ENGINEER models with the push of a button. Using multiple measures in 50 different areas of analysis, XMA enables you to understand the level of complexity in your models and identify areas for optimization. A 30-day free trial for XMA is now available so you can test this great tool - and your models!