Tutorial: Assigning Components to Choices

Assigning Components to Choices


Learn more with other tutorials...

Introduction to Options Modeler
  • Introduction to Options Modeler

  • |
  • 3878 Views
  • |
  • Introductory Level
  • |
  • In this tutorial you learn about Options Modeler. Options Modeler enables you to create two new assembly sub-types, Configurable Product and Configurable Module. You can run Options Modeler within Creo ... (Show more)
Creating Configurable Modules and Products
  • Creating Configurable Modules and Products

  • |
  • 3427 Views
  • |
  • Introductory Level
  • |
  • Options Modeler enables you to create two new assembly sub-types Configurable Product and Configurable Module. A Configurable Product is an assembly or sub-assembly within Options Modeler and a Configurable ... (Show more)
Utilizing the Variant Builder
  • Utilizing the Variant Builder

  • |
  • 2648 Views
  • |
  • Introductory Level
  • |
  • Variant Builder is used to configure the assembly, within it you can choose from using either Options Selection or Model Tree Selection modes to specify choices.
Analyze your Creo models Download the free XMA trial version

Analyze your Creo models and improve your modeling practices

PTC University Expert Model Analysis (XMA) assesses models in 50 areas of analysis around Geometry Quality, Design Intent Strength, and Model Complexity. Free 30-day trial available!
Learn more about XMA   
Replay video? Resume video